Gas Push Fit Gas Regulator + Dial Level Gauge

# Gas Push Fit Regulator with Dial Gauge

This is a great product as it gives you a guide on the dial of the gas level in your bottle, helping to prevent being caught out with no gas.

**Technical information:**

This is a single-stage push fit gas regulator preset to 37mbar to EN12864. Please note that on some older-style gas bottles, there may not be enough room to fit this type of regulator with the dial within the handle/shroud area.

The regulator is only suitable for gas bottles with the following type of fitting:

## How to connect 7kg, 12kg, and 15kg Gas Bottles

- These cylinders have a 21mm valve and should only be used with 21mm regulators.

- Remove the orange dust cap by pulling the lanyard out, and then upwards. Avoid using tools for this and just leave the cap hanging.

- Check that the black sealing washer is fitted inside the cylinder valve.

- Make sure the regulator switch is in the disconnect position (3 o'clock position).

- Fit the 21mm regulator as the manufacturer's instructions suggest.

- When you need to use gas, turn the switch anticlockwise to the 'on' position.

**IMPORTANT:** If the regulator on/off switch gets stuck when turning the supply on, it means the regulator has not been connected correctly. If this happens, disconnect it and follow the instructions to reconnect it.

## How to disconnect 7kg, 12kg, and 15kg Gas Bottles

- Turn the regulator switch clockwise to the off position.

- Remove the 21mm regulator as the manufacturer's instructions suggest.

- Replace the orange safety cap onto the empty bottle valve.